sorry už daug english , mokėčiau - išverščiau.
stiprius:
output max - 1500w
output 4ohm (1)* - 4 x 125w rms
output 2ohm (2)* - 4 x 250w rms
output bridged - 2 x 500 w rms
distortion all channel driven - <0.02%
frequency response linear bandwidth - 10hz-50k hz +,-1db
signal to noise ratio full band width @ rated power - >100db
damping factor @ output connector full band width - >200 at output connector
input level - 0,25v a 6v
input impedance - 10k ohm
(ten toliau apie H ir L filtrus rašo)
1*all channels driven, continuous 4ohm load, 20hz to 20,000hz, <0.1%THD, power input voltage at 13.2vdc
2*all channels driven, continuous 2ohm load, 20hz to 20,000hz, <0.1%THD, power input voltage at 13.2vdc
subas:
impedance - 2 x 4 ohm
frequency response - 23hz-400hz
sensitivity - 89db
voice coil - 2 x 2,5''(65mm)
fs - 22hz
vas - 76lts
Xmax - 19mm
Qts - 0,41
rms - 400w
max - 1000w
wounting depth - 6,75''(171,45mm)
(dviejų ričių)
kaip geriau jungti subo rites prie stipriaus? nuosekliai ar lygiagrečiai ? kaip "sužais" varža?
