Tai kad viskas parašyta tik išsiversk iš anglų kalbos ir suprasi pats.
Infrasonic filter - nufiltruoja žemiausius dažnius, kad negrotų to ko nebeatkuria kolonėlės, galima naudoti priešbosiams.
LP filter - nufiltruoja žemų dažnių viršų, kad nebegrotų kolonėlės vidutinių ir aukštų gros žemus iki kiek pastatysi reguliatorių, tavo atveju duoda reguliuot nuo 40-200 hz.
Mode slope - kirtimo statumą reguliuoja.
Input voltage - reguliuoja linijinių signalo lygį, statai priklausomai koks išeina signalas iš audio šaltinio.
čia aprašyta:
Input Voltage Range: A wide range of signal input voltages can be accommodated by the 500/1v2’s input section (200mV – 8V). This wide range is split up into two sub-ranges, accessible via switches located in the “Amplifier Input Section” of the amplifier. The “Low” position on the “Input Voltage” switch selects an input sensitivity range between 200mV and 2V. This means that the “Input Sens.” rotary control will operate within that voltage window. If you are using an aftermarket source unit, with conventional preamp-level outputs, this is most likely the position that you will use. The “High” position on the “Input Voltage” switch selects an input sensitivity range between 800mV and 8V. This is useful for certain high-output preamp level signals as well as speaker-level output from source units and small amplifiers. To use speaker-level sources, splice the speaker output wires of the source unit or small amplifier
onto a pair of RCA cables or plugs or use the
JL Audio ECS Speaker Wire to RCA adaptor (XB-CLRAIC2-SW).
pilnas aprašymas: http://mediacdn.jlaudio.com/media/mf...pdf?1305783844
Bookmarks